Designed for harsh environments, the Inclinometer (Slope Meter) is supplied in a rugged ABS plastic enclosure with integrated buttons and 4.3” colour LCD graphics display. Also included, a fully adjustable RAM 1” ball mount, allowing for optimum positioning for the operator.
Both pitch and roll can simultaneously be displayed, with the ability to display yellow on warning and red on alarm in the event of an alarm or warning condition.
The angles are given in the unit selected (degrees or percent-gradient) in the System Settings menu.
Warning and alarm levels are user configurable through the password (optional) protected menu. When a warning level is exceeded, the critical reading will be highlighted yellow and an internal audible alarm will begin to beep. When an alarm level is exceeded, the critical reading will be highlighted red and the alarm will sound continuously. Two positive drive outputs are provided that can be set to activate or deactivate on warning and alarm. The alarm can be turned on/off in the system menu.
The display is highly visible day or night due to the use of an industrially rated transflective graphics LCD colour display. This allows the display to be positioned at an optional angle for operator visibility whilst allowing for accurate angle measurement.
The integrated keypad allows for customisation of the display; in application calibration; warning and alarm setup; minimum and maximum tilt display and sensor customisation.
One HMTS2F0000B 2-axis high-accuracy Mobus tilt sensor is included, with a 7m cable length. When used in combination with the Inclinometer (Slope Meter), accuracy of one degree and customisable frequency response are achievable.
Integrated alarm and warning relays low current positive drive outputs. Both warnings and alarms can be configured to be normally-on or normally-off.
Add to Quote
